Tesla Model 3 Highland Logo Badges and Trim Clips: A Complete Fastening Guide

Owners of the Tesla Model 3+ Highland frequently ask how to properly secure aftermarket badges, trim pieces, and small exterior or interior accessories without compromising fit or causing panel damage. While TESLARY does not stock a dedicated badge-and-clip fastener kit, many of the accessories in our current range rely on the same fastening principles — adhesive backing, precision-cut mounting points, and clip-style retention — that are essential knowledge for any Highland owner planning a trim upgrade. This guide walks through the fastening considerations relevant to several of our accessories in stock, engineered specifically for the Model 3+ Highland and Model Y+ Juniper platforms.

Understanding Fastening Types on the Highland Platform

The Model 3+ Highland introduced revised panel gaps, a redesigned front fascia, and updated camera housings compared to the original Model 3. This means fasteners and covers designed for earlier Model 3 variants are not always compatible. Our Protective Side Camera Cover, for example, is offered in both a standard version and a Hardware 4.0 version, since the Tesla 3+ Highland and recent Model Y units use the newer HW4.0 camera housing with different mounting geometry. Before ordering, confirm which hardware version your vehicle uses — if in doubt, the standard cover is designed to accommodate both, reducing the risk of a mismatched fit.

Similarly, our Rear Air Vent Covers for Model 3 and Model Y use a precision-molded ABS shell that clips over the factory vent and USB housing without requiring adhesive. Correct alignment of the mounting tabs before applying pressure is critical: forcing a misaligned cover can stress the plastic clips and lead to a loose fit over time.

Step-by-Step Installation Principles

While each accessory has its own fitting instructions, the following sequence applies broadly to clip-and-adhesive trim pieces on the Highland:

  1. Clean the surface. Remove dust, wax residue, or detailing products from the panel before fitting any adhesive-backed accessory. This is particularly relevant for our Steering Wheel Upgrade Cover, engineered in ABS plastic with a paste-on application. A clean, dry surface ensures the cover adheres evenly and can be removed later without leaving residue or damaging the factory button surface.
  2. Dry-fit before committing. For clip-based accessories such as the Rear Air Vent Cover, position the piece without pressing it fully home. Confirm all tabs align with their corresponding recesses.
  3. Apply even pressure. Once aligned, press firmly and evenly across the panel rather than at a single point. This distributes clip tension and reduces the chance of a popped corner.
  4. Allow adhesive to cure. Where adhesive is used, avoid heavy use of the affected surface (such as steering wheel buttons) for the first few hours to allow full bonding.

The same logic applies to our Non-Slip Aluminium Sport Pedals, designed for the Model 3, Model 3 Highland, Model Y, and Model Y Juniper. These are engineered for a direct, secure fit over the factory pedal pads, and correct seating is essential both for aesthetics and for safe pedal operation.

Compatibility Checks Before You Order

Precision engineering means Tesla accessories are rarely universal across every model year. Before purchasing badges, trim, or clip-style covers, verify the following:

  • Model year and variant — Highland (Model 3+) and Juniper (Model Y+) revisions often require different mounting points than earlier builds.
  • Hardware version — particularly relevant for camera covers, where HW3.0 and HW4.0 housings differ in shape.
  • Wheel size, where applicable — our Aluminium Brake Caliper Covers are designed for Model Y with 19/20-inch wheel hubs and Model 3 / 3+ Highland with 18
Back to blog